|
ELMACH - MASZYNY CNC
Wygiełzów 35a 27-570 Iwaniska POLAND |
ELMACH - ODDZIAŁ MOSTKI
Mostki 66D 28-200 Staszów POLAND |
|
OPENING HOURS
Mon-Fri 08:00 - 16:00 |
PHONE
+48 888-027-736 |
|
EMAIL
cnc@elmach.net |
BANK ACCOUNT
PL 04 1140 2004 0000 3302 6845 3852 SWIFT: BREXPLPWMBK |
Water mist shielding - WMS.
15/03/2020, 11:53
By using N2 / H2O instead of H35 / N2 gas, we reduce gas costs, cutting speed is increased, and material distortion and temperature zone are minimal. The result is a clean, unpolluted and non-oxidized cutting surface, ready for welding, forming and painting.
How does water fog cutting technology work?
During the cutting process, water is separated from the shielding stream into the main elements - hydrogen and oxygen. Hydrogen creates a special atmosphere in the cutting zone, separating it from pollutants at a much lower cost per meter than other types of cuts. Because this method uses ordinary tap water, Water Mist Technology also reduces production costs and keeps energy consumption to a minimum. WMS Technology is recommended for non-ferrous cutting up to a depth of 40 mm.
Benefits of use water mist shielding cutting technology
- Lowest machining costs
- Up to three times faster cutting compared to H35 cutting
- Unpolluted cut at a depth of 1 to 40 mm
- Non-oxidized cutting surface
- The wide spectrum of parameters allows you to get the best results
- Operator friendly
- Aluminum cutting quality comparable to laser
- Small temperature zone with less pollution
- Cutting surface ready for welding
We have WMS technology dedicated to the Hypertherm Powermax family of cutters thanks to which it is possible to cut stainless steel and aluminum covered with foil.